HO Scale Plywood Sub-Roadbed Cutouts Search Shopping

5

Very Easy To Use !

Reviewed on www.ebay.com·bben1082

All I had to use was wood glue on a small 4" wide roller and a tray and I rolled the back of this foam road bed and it would stick great! On curves you might have to use small track nails to help hold it in place. But it looks very nice when you are all finished.

4

New user, new convert!

Reviewed on www.ebay.com·rthomash

I wasn't sure about Track-Bed at first, but I quickly came to prefer it for HO scale roadbed over cork or homasote. I simply nailed it down to my plywood base using Atlas rail spikes and then glued the track to it using Woodland Scenic's glue. I even super-elevated my curves using 5/8" masking tape applied to the outer radii, which adhered to the roadbed without a problem. The roadbed features a split down the center which is VERY handy for laying it on a curve. It cuts extremely easy with a sharp hobby razor knife. Its 5 mm (5/16") height is an HO scale 27".\n I could not mount my turnout ground throws on it, as it doesn't offer a stable enough platform (too squishy). But a 5/16" thick piece of strip wood matched up perfectly to the roadbed height.\n As for sound deadening, there is ZERO sound transferred to the wood table top from a train running on the tracks. This is great stuff and will be my go-to material to use in the future.

5

Woodland Scenics Foam Track-bed works best with their ST1477 Foam Glue

Reviewed on www.ebay.com·gregor2407

The Woodland Scenics foam track-bed stays down well with their ST1477 Foam Glue. (I found that the regular white glue required tacks to keep the foam down.) I cut along the partially-cut center-line of the foam for the curves, and laid it with no wrinkles or bumps. I only wish that they offered the foam in a tan color to match the older cork-board on my layout.

5

Woodland scenics foam track bed

Reviewed on www.ebay.com·whtetalhntr

I'm using the HO scale track bed. If your looking for an easy to use, low cost track bed with good noise control, this is a great choice. I used tack glue and a few strips of left over 1/4"plywood to hold it tight in place until the glue set. I'm only starting my set, but was eager to run a few trains ,just to check it out, even without any scenery in place it's already very quiet.

5

Works great

Reviewed on www.ebay.com·droop_55

First time using this I was skeptical. But I managed it and it works great. Easy to cut and bend. Recommend

5

Woodland scenics HO track-bed roadbed

Reviewed on www.ebay.com·bmackn1949

This product was easy to lay on foam. It also works well as multiple tracks side by side. I would recommend this for bench layouts or small yards. Locomotives wheel noise is minimal and metal car wheels.

5

Woodland Scenics Road Bed

Reviewed on www.ebay.com·msgdlsmith

Much easier to use than cork. Just pin it in place, double check correctness of curves, etc... then I just foam tack it down with woodland scenic foam glue. works great and seldom needs special cutting. some curves may require some angle cuts, but this makes roadbed a no brainer.

5

HO Track Bed 24' Continuous.. Not Called that anymore !

Reviewed on www.ebay.com·73firebirdformula400

There was one issue with product, Its a old version.. Tried buying more at a local hobbie store and New Version is Made Different

3

All in all a good product

Reviewed on www.ebay.com·frtak77

Two of the 3 rolls that I purchased had the center line on the wrong side, they were also a little bit wider and a little bit thicker. I still used them, easy to work with.